DuncB
Well-Known Member
Bruce you were after a suggestion to secure temp probe.
Somewhere I saw the mention of plumbers putty. I don't have any of this but have used blu tack to hold the probe onto the side of the fermenter and then put a piece of sleeping mat foam on top of this held on with a bungee cord. Much better than my previous double sided tape and foam insulation method.
I like the axial fans you've used to promote airflow over the condenser. I'm not sure which way the hot enters the condenser grid but you might find a cross flow or up flow is better ( heat rising etc ) something to experiment with.
Somewhere I saw the mention of plumbers putty. I don't have any of this but have used blu tack to hold the probe onto the side of the fermenter and then put a piece of sleeping mat foam on top of this held on with a bungee cord. Much better than my previous double sided tape and foam insulation method.
I like the axial fans you've used to promote airflow over the condenser. I'm not sure which way the hot enters the condenser grid but you might find a cross flow or up flow is better ( heat rising etc ) something to experiment with.