DuncB

While since I've seen a 3.x My bigger AIO has half inch tube on the recirculation.

Beware the unit will suck grain back up the tube when pump is turned off. Keep it on top plate or out of the wort. You might find that...

Would be ideal if it could cycle ispindel temp displays from multiple Ispindels even if only controlling via ispindel / temp sensor for...

Not sure I wrangled it from an 8 wired keg of barrel aged Brett only ferment beer.

@pocketmon That looks very good already.

I've done this with my AIO. I use a strainer to pull out the mash and place it in a large sauce pan... take it to the kitchen stove and...

I do apologise for the late response, I am really sorry: I've been completely absorbed by work and couldn't find 5 minutes to get back...

I am familiar with this issue: I have seen two major failure-points in "cheap" TP40565 modules available online. In most of the cases...

Got my mild to brew today. Due to travel and knee replacement been almost 3 months since my last brew.

I was having an issue building the C3 iSpindels where the battery would charge and the charging LED would light up red, but the ESP32...

Well it's a sugar and glucose and galactose are fermentable.

HCl is pretty nasty stuff to have around. It produces HCl gas that corrodes the heck out of most metals around it. The other thing to...

Could be spunding helping with tiny bubbles for the foam as well?

The bulk of the water is at or very, very close to boiling temperature. The wall of the kettle is necessarily hotter, depending on the...

You could starsan shake them and then squirt in a few ml of ascorbic acid solution made with boiled then cooled water. Might reduce...