Weldless spigot to 8gal pot?

[Tok]

I'd like to add a spigot to my aluminum pot. Anybody know an online source for cheap parts for this?

Also how high from the bottom should it be? I was thinking maybe 2 inches.

 

[MyNameIsPaul]

www.brewhardware.com

Check out the weldless kit, and get your step bit for making the hole from him as well. Service can't be beat!

 

[MyNameIsPaul]

As far as hole height, I'd go as low as possible. So put the bottom of the washer as low on the pot as possible, until the bottom of the washer gets to the rounded part of the pot, and mark your spot.

 

[Tok]

Sounds good thanks guys

 

[DanH]

I just bought one from weldlessfittings.com and they're awesome. There's also bargainfittings.com.