T Tok Member Joined Aug 20, 2013 Messages 7 Reaction score 0 Aug 27, 2013 #1 I'd like to add a spigot to my aluminum pot. Anybody know an online source for cheap parts for this? Also how high from the bottom should it be? I was thinking maybe 2 inches.
I'd like to add a spigot to my aluminum pot. Anybody know an online source for cheap parts for this? Also how high from the bottom should it be? I was thinking maybe 2 inches.
MyNameIsPaul Well-Known Member Joined Jul 6, 2010 Messages 1,057 Reaction score 162 Location Tomball Aug 27, 2013 #2 www.brewhardware.com Check out the weldless kit, and get your step bit for making the hole from him as well. Service can't be beat!
www.brewhardware.com Check out the weldless kit, and get your step bit for making the hole from him as well. Service can't be beat!
MyNameIsPaul Well-Known Member Joined Jul 6, 2010 Messages 1,057 Reaction score 162 Location Tomball Aug 27, 2013 #3 As far as hole height, I'd go as low as possible. So put the bottom of the washer as low on the pot as possible, until the bottom of the washer gets to the rounded part of the pot, and mark your spot.
As far as hole height, I'd go as low as possible. So put the bottom of the washer as low on the pot as possible, until the bottom of the washer gets to the rounded part of the pot, and mark your spot.
OP OP T Tok Member Joined Aug 20, 2013 Messages 7 Reaction score 0 Aug 28, 2013 #4 Sounds good thanks guys
DanH Well-Known Member Joined Jun 11, 2012 Messages 1,020 Reaction score 83 Aug 28, 2013 #5 I just bought one from weldlessfittings.com and they're awesome. There's also bargainfittings.com.