Does anybody know what the thread size is for a NukaTap Mini?
I want to make custom tap handles for a set of NukaTap Mini taps but don't know the actual thread size. The KegLand page says it's M6x0.75. I'm new to taps & dies but have an OMT sets of SAE and metric, including M6x0.75, but if I loosely twist the tap into the existing handle, it doesn't fit, seems the thread pattern is off. Same thing if I try a die on the tap threads, they snugly twist on for almost 1 full turn, then start binding. Maybe this is normal for tap & die since they're designed to cut?
Nukatap Mini - Tap only
I can probably drive to my nearest hardware store and see if they have any bolts that touch-align with the tap's threads, I just don't have one close by and would rather see if somebody here might already have the answer before I blow $20 in gas (or likely $30 by the time you guys read this, lol).
Thx in advance, any help is greatly appreciated.
I want to make custom tap handles for a set of NukaTap Mini taps but don't know the actual thread size. The KegLand page says it's M6x0.75. I'm new to taps & dies but have an OMT sets of SAE and metric, including M6x0.75, but if I loosely twist the tap into the existing handle, it doesn't fit, seems the thread pattern is off. Same thing if I try a die on the tap threads, they snugly twist on for almost 1 full turn, then start binding. Maybe this is normal for tap & die since they're designed to cut?
Nukatap Mini - Tap only
I can probably drive to my nearest hardware store and see if they have any bolts that touch-align with the tap's threads, I just don't have one close by and would rather see if somebody here might already have the answer before I blow $20 in gas (or likely $30 by the time you guys read this, lol).
Thx in advance, any help is greatly appreciated.