roddog
Active Member
- Joined
- Dec 29, 2013
- Messages
- 42
- Reaction score
- 3
OK, so I'm converting a 10 gallons SS Brewtech kettle into a HERMS HLT and have a question. In this 'weldless' approach, I see that my coil 'sags' a bit in the kettle, deforming the side of the kettle a bit (nothing too extreme but noticeable).
Anyone see this? I'm thinking that perhaps I should create a 'leg' for the back side of the coil to rest on the bottom of the kettle and support my sagging tube..
Anyone see this? I'm thinking that perhaps I should create a 'leg' for the back side of the coil to rest on the bottom of the kettle and support my sagging tube..