I followed this method: [ame]https://www.youtube.com/watch?v=LJ_YGcJEcOc[/ame]
and it seems pretty straightforward. I turned up to 30psi, laid the keg down on its side, and rolled it back and forth for about a minute, and then disconnected the gas and let it sit for 24 hours. I hooked up my gas and beer lines today and set to serving (10 psi) and went to pour myself a beer. Beer came out, but it was flat.
I don't think my force carbonation took (obviously). What should I do now? Should I try the same method again? I'd like a little bit of a faster solution than letting sit at my serving pressure for a week.
FWIW - I heard very little hissing of the CO2 going into solution when I was rocking it. Did I not slosh it around hard enough?
and it seems pretty straightforward. I turned up to 30psi, laid the keg down on its side, and rolled it back and forth for about a minute, and then disconnected the gas and let it sit for 24 hours. I hooked up my gas and beer lines today and set to serving (10 psi) and went to pour myself a beer. Beer came out, but it was flat.
I don't think my force carbonation took (obviously). What should I do now? Should I try the same method again? I'd like a little bit of a faster solution than letting sit at my serving pressure for a week.
FWIW - I heard very little hissing of the CO2 going into solution when I was rocking it. Did I not slosh it around hard enough?