:rockin: For the size keezer i was about to build, this was the perfect alternative. I bought a tower, and all the brew supplies from MicroMatic and the whole shabang plus the cornies and attatchments for 300...it was looking at the same prices for a small keezer. I took the top off and dug through the foam and found where not to drill. Place the holes NOT on the coils and support with a 2 by 4. If you dig out an insert the sixe of your wood and reinforce with liquid nails...then you're set. this is a great kegerator, and it was fun and super easy to build. Trust that it's worth the time and effort to dig around where you want to put your tower (i can't see how this would be near as convinient with door mounting...door is too short, and easy to bump into). The coolant lines are obvious and easy to avoid and if you're mounting the Co2 outside, you should go through the drain plug. All in all, my pumkin beer tastes great out of it, and thanks to all the previous posters for the advice!
Cheers!