Is there a thread or some general info regarding using a flow meter in a brewing setup? (I'm tired of missing my batch sparge total...I swear my pump puts out varying amounts of water.)
He would also need an Arduino SBC and code to read it out.
Surely the guys over at brewtroller will be able to figure something out (plus I think I saw some example code on seeedstudio's website for it to make their job a bit easier, not that I think they would need it )
But yes, you would still need to buy a brewtroller then.
When it comes to a question like this I tend to imediatly think "automation" even if it is not the case, my bad . If it is a physical means to measure volumes I would just stick with the tried and true sight gauge.
Enter your email address to join: