bakins
Well-Known Member
Just started today, but when doing my boil at 70%, I hear a buzz everytime the SSR turns the element on. Not sure where it's coming from. Element is a 4500watt from HD and the SSR is from Auber. Any ideas?
"Buzz" in element or ssr
- Thread starter bakins
- Start date
Help Support Homebrew Talk:
Bubba_Mustafa
Well-Known Member
I doubt an SSR would buzz.
Does the buzz go away after a few seconds? If so, it can just be from the E/C cycle (expansion/contraction) as it heats up.
Does the buzz go away after a few seconds? If so, it can just be from the E/C cycle (expansion/contraction) as it heats up.
Somewhere I read, maybe on a water heater element manufacturer's site, that if the element is oriented so the loop is on edge it may vibrate when under power. If the loop of the element is flat (horizontal), it shouldn't buzz. Don't know if this will help, but may be worth a try to turn the element 90 degrees and see if this changes things.
OP
OP
bakins
Well-Known Member
It seems to have gone away by the end of the boil. Best I could tell it was the element, though it is horizontal. Weird...
Spine
Well-Known Member
Don't worry!
I have an electric keggle and electric HLT (both 4500w) and depending on the amount of water and the temperature, they will both start to "howl" but this usually only lasts until the water is at a rolling boil or until the volume changes a bit! I have done about 20 batches so far and the element hasn't burnt out.
I have an electric keggle and electric HLT (both 4500w) and depending on the amount of water and the temperature, they will both start to "howl" but this usually only lasts until the water is at a rolling boil or until the volume changes a bit! I have done about 20 batches so far and the element hasn't burnt out.
Similar threads
