Hi. I'm preparing to put together a HERMS brewing setup. I'll use manual valves initially, but may replace them later with automated valves and go full auto. This system uses one PID controller that always controls the HLT heating element. You can see a schematic of the flow layout here:
http://pastebin.com/Dybw7JYu
I'm interested in any advice that anyone might care to share as to what's good and bad about this plan.
Thanks,
Kip
http://pastebin.com/Dybw7JYu
I'm interested in any advice that anyone might care to share as to what's good and bad about this plan.
Thanks,
Kip