slowloris
New Member
- Joined
- Dec 8, 2020
- Messages
- 3
- Reaction score
- 4
I built a small keezer from a 3.5cu.ft freezer. It is snug, but can fit two ball lock kegs and a 5lb CO2 tank inside.
The collar is 9" tall for keg clearance and lined with 2 layers of foam board insulation.
Made a small wooden platform to fill the 7" gap next to the compressor bump.
The total useable space inside is about 16" (length) x 16.5" (width) x 26.5" (height).
Mounted a 5" computer fan with a 12V power supply to the inside collar to recirculate the cool air.
Inkbird ITC-308 temperature controller used.
Clipped some SOLO cups to the side with magnets to catch the drips.
Enjoy!
The collar is 9" tall for keg clearance and lined with 2 layers of foam board insulation.
Made a small wooden platform to fill the 7" gap next to the compressor bump.
The total useable space inside is about 16" (length) x 16.5" (width) x 26.5" (height).
Mounted a 5" computer fan with a 12V power supply to the inside collar to recirculate the cool air.
Inkbird ITC-308 temperature controller used.
Clipped some SOLO cups to the side with magnets to catch the drips.
Enjoy!