So i'm pulling together the pieces to convert my kettle into an E- kettle Via Kal's technique.
I've decided to go with this deep single gang box so that I can have a power switch as an additional safety measure.
I'm not the most electrically inclined so I want to run it by you guys.
Iv'e got the hot white cable that will be attached to the back of the element. And the black attached to one end of the switch.
I'll have another length of Black going from the element to the other bolt on the switch. Everything right so far?
Now for the ground there is a big ground bolt on the gang box and one on the switch. Can I just take the single ground wire and put it to either? I don't need to have a wire going to the element to the ground too right?
I've decided to go with this deep single gang box so that I can have a power switch as an additional safety measure.
I'm not the most electrically inclined so I want to run it by you guys.
Iv'e got the hot white cable that will be attached to the back of the element. And the black attached to one end of the switch.
I'll have another length of Black going from the element to the other bolt on the switch. Everything right so far?
Now for the ground there is a big ground bolt on the gang box and one on the switch. Can I just take the single ground wire and put it to either? I don't need to have a wire going to the element to the ground too right?