Pin-Lock O-Ring size again?

[bracconiere]

title says it all.

i know it's been said but if i remember it's a #9 for ball lock and #10 for pin lock right?

i got my pin lock hooked up with a ball lock o-ring. but i think it's leaking my co2 tank lost 10 grams of co2 in a day...i poured 14 yesterday, but at 2grams a 6 pack...i think it's a leaky..

just wanted to double check before i order the o-rings, Thanks!

 

[Nagorg]

See this sticky.

 

[bracconiere]

didn't realize it was a sticky already...



3/32 thick
1/2 id
11/16 od


went with this....hopefully it does the trick...for the time i'm going to get the side weight off my gas post, hopefully that helps. it's my only keg of beer right now....

 

[NTBeer]

https://www.oringsandmore.com/metric-buna-o-rings-10-77-x-2-62mm-minimum-50-pcs/
I use these for pin lock posts.

 

[camonick]

Here is a thread where we discussed this not too long ago.

 

[bracconiere]

Here is a thread where we discussed this not too long ago.

that's one i was thinking of...just wanted to double check the #10 i think.....

i ordered a 5 pack of the ones i mentioned. $2.xx....i got the weight off my kegs gas post from the other line pulling it to the side, hope that works as a band-aid till the rings arrive...


i only lost one kegs purge to it....glad i keep i close eye on things like this!

 

[bracconiere]

https://www.oringsandmore.com/metric-buna-o-rings-10-77-x-2-62mm-minimum-50-pcs/
I use these for pin lock posts.

i ordered a 50 pack for $4.50, just in case the other ones don't work.....i'm glad it least the lids are interchangable.....