DownRightAft
Member
- Joined
- Feb 17, 2009
- Messages
- 22
- Reaction score
- 0
I am building a small electric brewery, using a stainless table, and stainless kettles. I am planning on running a ground wire to the element, and I want to enclose the wires in waterproof rubber shrink wrap. I am using a double O-Ring setup to mount the element to my kettle.
My question is, if I ground the stainless table that the kettles are sitting on, will that be sufficient to ground the kettles as well? I am pretty sure the large surface area of the two stainless surfaces touching would work, anybody else doing this? If I can avoid drilling another hole in my kettles for a ground wire I would like that. One less place for a leak. Thanks.
My question is, if I ground the stainless table that the kettles are sitting on, will that be sufficient to ground the kettles as well? I am pretty sure the large surface area of the two stainless surfaces touching would work, anybody else doing this? If I can avoid drilling another hole in my kettles for a ground wire I would like that. One less place for a leak. Thanks.