Hi All,
I recently build a eHERMS control box, and used it flawlessly once. Now, every time the probe goes into the mash OR the HLT (I put it in there to get the HLT to temp for the HEX before the mash), the PV temp jumps everywhere (145, 156, 130, 142, all within 5 seconds). Strangely, when I remove it from the mash and put it into a cup of water, the temp stabilizes, accurately, in seconds. What gives? It's rendering the panel essentially useless, and I'm pretty much out of ideas. All I can think of is maybe the HLT and mash are electrically charged somehow? Any help is appreciated.
I recently build a eHERMS control box, and used it flawlessly once. Now, every time the probe goes into the mash OR the HLT (I put it in there to get the HLT to temp for the HEX before the mash), the PV temp jumps everywhere (145, 156, 130, 142, all within 5 seconds). Strangely, when I remove it from the mash and put it into a cup of water, the temp stabilizes, accurately, in seconds. What gives? It's rendering the panel essentially useless, and I'm pretty much out of ideas. All I can think of is maybe the HLT and mash are electrically charged somehow? Any help is appreciated.