nebben
Well-Known Member
I ordered one from Northern Brewer and another from Bargainfittings. The bargainfittings parts won out because I decided I wanted 1/2" NPT fittings.
This is new and unused.
This kit assembly from Northern Brewer that includes 1/4" NPT pieces that are threaded together with silicone o-rings on the inside and outside of the cooler. It has brass fittings with compression nuts (and o-rings for each) for the thermometer probe and the sight glass on the T. A long-ish polycarbonate tube is included as well, which is approximately the same height as a 10G cooler from bottom to top.. This kit looks like it would fit probe type thermometers such as the Miljoco 5" dial face type. Northern Brewer's website indicates it is a little too small for the Brewmometer, so be advised.
The whole thing looks like it would fit a 10G round cooler's wall perfectly.
A stainless eye bolt is included with two nuts, but it looks like it might not have enough thread to bite into the cooler wall.
Asking $20.00 plus whatever USPS comes out to be.
This is new and unused.
This kit assembly from Northern Brewer that includes 1/4" NPT pieces that are threaded together with silicone o-rings on the inside and outside of the cooler. It has brass fittings with compression nuts (and o-rings for each) for the thermometer probe and the sight glass on the T. A long-ish polycarbonate tube is included as well, which is approximately the same height as a 10G cooler from bottom to top.. This kit looks like it would fit probe type thermometers such as the Miljoco 5" dial face type. Northern Brewer's website indicates it is a little too small for the Brewmometer, so be advised.
The whole thing looks like it would fit a 10G round cooler's wall perfectly.
A stainless eye bolt is included with two nuts, but it looks like it might not have enough thread to bite into the cooler wall.
Asking $20.00 plus whatever USPS comes out to be.