Digitizer101
Active Member
I have been trying to find the best place to add the temp probe for the STC-1000 to monitor temperature of HLT and Mash Tun. And to control the burner solenoids. I was thinking of locations and all have +'s and -'s just not sure which is best.
I would get better temp readings up closer to keg but I wouldn't have to remove and reinsert every time when down by the pump.
All options require me to run a continuous re-circulation to get a reading and that is the down side to adding the probe in line.
The middle option leave a rather long pipe on the side of the keg.
Any other ideas welcome
Thanks
![Probe1.jpg](https://proxy.imagearchive.com/abc/abccc81bae57190493c811f22e043d3a.jpg)
![Probe2.jpg](https://proxy.imagearchive.com/83e/83ebe7d8fcea0177567e80e76eb508e2.jpg)
![Probe3.jpg](https://proxy.imagearchive.com/5e8/5e8627e73825b56ef4cbcac31548768b.jpg)
I would get better temp readings up closer to keg but I wouldn't have to remove and reinsert every time when down by the pump.
All options require me to run a continuous re-circulation to get a reading and that is the down side to adding the probe in line.
The middle option leave a rather long pipe on the side of the keg.
Any other ideas welcome
Thanks