Noob_Brewer
Well-Known Member
So I have a tap rite secondary regulator in my keezer with the polycarbonate bonnets and the regulator that I typically adjust lots because its a "spare" regulator has stopped being able to adjust pressure. I thought that the plastic bonnet was just stripped so I ordered and received (today) a few new bonnets. However, after taking the plastic bonnet off, I can see that the plastic was certainly worn but not completely stripped. And when I tried to take an allen wrench to manually adjust the actual adjustment screw, it will only turn about a half of a turn and that is it. So this regulator is essentially stuck at ~10psi now. Do you think I simply need to purchase another adjustment screw and housing as a whole? In retrospect, while the plastic "tooless" bonnets seem attractive, Ive been annoyed with these regulators to be honest. Thoughts on why I cannot adjust the screw with the allen wrench? The adjustment screw just seems stuck and won't adjust. Thanks in advance.
EDIT this is a 1660SN series tap rite regulator.
EDIT this is a 1660SN series tap rite regulator.