Drilling into the top of a Series-X

Homebrew Talk

Help Support Homebrew Talk:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Broken Crow

Ale's what cures 'ya
HBT Supporter
Joined
Oct 12, 2020
Messages
2,965
Reaction score
4,738
Hey @KegLand .. I thought about emailing you but there might be others who want to know; I love my Series-X and I used all the included bits at the start which means all 4 gas disconnects coming off the same line..No big deal as I don't yet have any secondary regulators, but on a couple occasions I have slightly overfilled kegs and had a bit of of beer or foam shoot up and contaminate the gas line when I connected. Pulling all the disconnects off and disconnecting the regulator end to clean it out is a PITA, so as a precautionary stepping stone until I can afford secondaries, I'm putting in a 4-way manifold to have the shutoffs with the integrated check-valve. I want to mount it against the back of the plastic top of the unit, drilling 2 small holes and using self-tapping screws, but I need to know if there is any wiring such as for the fan, temp sensor...anything on the immediate inside of that shell. Here's where I want to put it:
IMG_1656.jpg

Anyone know if it's ok to drill here?
:mug:
 
Back
Top