single tier brew stand propane lines

[jbf101]

So I just started my brew day with my newly built brew stand. I have it rigged with propane lines. Everything is going great then Bam. Burners go out . Switched tanks, turned everything on and off a couple times. Still nothing. I switched the burners directly to the tanks, so everything is still going. It seems like the burners have no pressure when hooked up to the stand. Everything is Teflon taped and had pipe sealant. So I don't think it's aleak. Any thoughts?

 

[ChuckO]

Do you have all burners run from one regulator? If so there might have been too much gas flow which shut off a safety valve in the regulator.

 

[davygoat2]

I don't think the safety valve is in the regulator.
The Tanks have a free-flow limiter. may need to buddy up another tank to
split the flow from the tank valves. Put 2 gauges up and downstream and run the system again, see where the psi drops.