Shower type spray nozzle for lock line

[moinkyschmoink]

Hi All,

I'm trying to find a solution to hook up what I attached. It's the end of a mega pot sparge contraption. I'd like to find a way to attach it to the open end of a lock line. Has anyone figured this one out yet?

Thanks ahead of time

 

[DuncB]

I'm thinking Fit larger plastic tube ( silicone probably ) as sleeve over the white bit and smaller plastic tube sleeve inside the black thing and if still not right add more tubing inside or outside until one fits into the other or you find bit of metal tube that corresponds to any of the above parts.

 

[moinkyschmoink]

I'm thinking Fit larger plastic tube ( silicone probably ) as sleeve over the white bit and smaller plastic tube sleeve inside the black thing and if still not right add more tubing inside or outside until one fits into the other or you find bit of metal tube that corresponds to any of the above parts.

I considered that, I was hoping to find a bigger spray distributor thing that might fit the lock line better than going through all the reduction with tubing and hose clamps.

 

[DuncB]

I considered a stainless steel watering can rose, but couldn't get it to fit on the tube.
Trouble is I'd really like on of those monsoon shower heads that dripped over the whole surface, but the flow would need to be so high it would jet blast the mash surface.
Ideally I want to just have a fly sparge adding water as it runs out, but at the moment my run off is far too quick for that. But I'm working on a finer crush to see if that helps and more sparge liquid.