I'm wondering if someone can help me with some questions. For some reason the setup for this seems to be escaping me.
I've successfully flahsed my ESP8266, when I go in to "Add New Temp Controller" I am prompted and indicate "Yes - Already Flashed". It comes back with the response:
"Perfect
Before you go to the next step, you need to get the controller to a state where we can connect to it. If you are using WiFi finish the controller setup and connect it to your network...."
It would be helpful in the instructions if it referred people back to the fermentrack documentation section 4.2.1 at this point. It took this knucklehead a while to figure out what that meant and how to do it. Also, that section of the doesn't clarify that you need to connect the ESP8266 to the USB of the Pi, and then connect to the access point via WiFi. (At least that is the only way I could even get it to show up in the network list.)
ok, so...I selected the ESP_13104009 network, then navigated to a web page (
www.google.com) and it redirected me to 192.168.4.1...but the page never seems to load.
Any tips?