You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
-
-
M
It will check the pins at startup so you will need to do a reset
-
M
If you dont get any more output then its most likely related to some issue with the gyro hardware or the i2c bus used for communication...
-
M
The log output looks fine, thats the normal output but not the final part of the startup procedure. Do you have a "web server started...
-
M
If the device is not calibrated it should go into configuration mode automatically so can you check the serial output and see what the...
-
M
Since I dont have a full version of the floaty I can only test that much. But from the log output it detects the pins and force the...
-
M
I can make that pin configuable so its backwards compatible. Will add it in the next release
if its not that far off 20-30 degrees you...
-
M
If the gyro calibration is off it will not go into config mode since the angle might not be close to 90
-
M
Would not matter since they should be connected
-
M
Actually never mind, if I calibrate it with the gyro facing flat it does work. My calibration was with the board perpendicular as it...
-
M
I just tested my mockup and I could get values from 90 to 0 when tilting the board in using the gyro in the same position as the video...
-
M
The axis should be the same as the ispindel but i noticed that the gyro is rotated 180 degrees but that should not really matter. Let me...
-
M
The orientation of the gyro can definitely have an impact on the reading. It needs to be aligned with the main board for the angle to be...
-
M
Crossing the pins still force the device into configuration mode on 1.4. Expect for bluetooth transmission there is no changes to...
-
M
I must admit that the floaty build for 1.4 has not really been tested, so its likely that some change has broken the build. I don't have...
-
M
Put on some keg lube on the rim, that helps with sealing.
-
Loading…
-
Loading…