Motorized mill complete!

[Dgonza9]

Thanks to everyone who posted their build. Here's mine.

My cord management wasn't the greatest, but it's hard to plan to box everything since the wires coming from the motor were so short. I might have used butt connectors instead of the wire caps, which would have given me more room to encase everything. I still might make changes in this regard, but it seems reasonable to me as is since everything is bolted down and not going anywhere. I wanted to get the mill ready for some brewing this weekend.

Time to set the gap!

Cheers!

 

[StMarcos]

I'm sure you'll be happy with the build. Mine is similar. The only problem I have is the static electricity causing flour to stick to the underside of the table. It then slowly falls off over weeks/months.

 

[snwmnhntr]

nice job!