Morning, all, and Happy New Year to everyone!
Finally got some free time, and with a larger amount of effort than I was expecting (solely due to my own inexperience), I've got KegCop up and running in my keezer. I'm using 3 flowmeters and 3/4 of the temp sensors (Upper, Lower, and Tower). No relays or temp control at this point. Everything, fingers crossed, seems to have survived my soldering, assembly, and installation. I've only encountered one thing I'm not quite able to figure out.
I'm on 1.2, and I'm trying to calibrate my flowmeters by volume. Everything seems to work fine reading the pulses when I dispense, but I can't get the "Set PPU" button to become active. I can reset, but can't set the new calibration. Also, I can't change from tap number 1 - when I click on the tap number, a list of taps flashes up quickly, then just disappears.
Not a huge deal - for my purposes, I probably don't need to calibrate that closely, but figured I'd ask the question to see if there's a known solution. I dug around the thread a bit but haven't seen anything like this recently - apologies if I missed something!
Thanks for everyone's work on this - I love these types of projects!
Tom