Grounding AC and DC on the same bus

[Bsquared]

Hi All,

Been building my new system for the past few months, and am done with the High voltage connections and am finishing up the wiring for all the low voltage controllers, All the high voltage AC power is grounded to the same bus, and was wondering if there is a problem with grounding all the DC powered components (BCS controller, seven segment display ) to that same bus? I've seen diagrams like this, but was looking for some conformation.

 

[BrunDog]

Yes, ground it all together, especially for the BCS to keep the probe temps steady.

To be clear... I mean tied the AC ground, not the neutral, to the BCS ground.

-BD

 

[Bsquared]

Cool, Thanks.

Yes I have them all tied to the earth ground not the neutral (green not white).

I did a few searches and this seemed to be the way to do it.