Wondered if this should be happening, and I how I can avoid this overshoot compensation happening.
I have set up a fridge with a 60w tubular heater. 3 temoeratemp probes - outside air, in fridge air, and beer.
Fridge air sensor is hanging in space 10cm from top of the fridge at the back, behind the fermenter.
Beer sensor is dangling in the beer through and new hole and grommit I put in the plastic fermenter lid.
60w tubular heater is installed horizontally at the bottom of the fridge, centrally under the fermenter (5cm below the base of the bucket). Bucket is propped up on legs.
Any ideas?