Well... today's brewing kinda went a little sideways on my b20 (original) unit.
I am on my third brew using the auto-in water for the brewing water.
Set up machine, calibrated, started it up.
All went fine, until the water had pumped over the mashing.
Mashing started, and then the water failed to stop filling for the sparge water.
Thankfully I caught it in time- and here is how I think I have saved the brew:
-I fully drained the boil side
-I drained the mash side and saved it
-I re-started the brew, and used manual water
-I just used the mash drain for the initial water
-I will manually add the sparge water.
Hopefully i can save this brew!
I know this was an issue in the past, but as i recall it was all either software or calibration (not doing it) related. Any other thoughts?
Thanks all!
Thanks @macgyuver for the reminder.
I am happy to report- rest of the brew day went great. Hit my O.G. spot on, so not a loss that i can see.
Also, on the subsiquent quick clean, and full clean runs- no issues with overfill.
Iirc, i *may* have been trying to log back onto the ap and/or has it just time out... so... i guess the moral for me is- keep an eye out for the auto water in cycle and dont fuss with the app around that time too.