Bottling is a pain in the ass, ant recommendations as to where to buy a kegerator
Wanting at least a 2 tap and able to hold minimum of 3 kegs.
thanks
Wanting at least a 2 tap and able to hold minimum of 3 kegs.
thanks
I started with a pre-built kegerator before I even homebrewed. It was a one-tap model similar to this one, which I ended up converting myself to a three-tap model by getting a slightly wider 2-tap tower and then drilling a hole for a third faucet as well.
If I was going to do it over, I'd just go all out and buy this one and have three taps. If you're going to have three kegs, might as well make sure they're all able to serve. And the price difference between the single-tap and the three-tap model is worth it.
I would HIGHLY consider replacing faucets with Perlick front-sealing models. This is available as an upgrade from Beverage Factory. But standard faucets stick badly if you aren't pulling beers daily (or more), and the Perlick will not have this issue. This is MORE than worth it, and you'll find yourself doing it down the road if you don't do it up front, so it's slightly cheaper to start with the good stuff.
Oh, and it's about the same price as the one you say you'd buy if you had it to do over again.
Can't say enough good things about beveragefactory.com and their customer service.
So basically everywhere...you can buy a kegerator everywhere
Upgrade or switch to Perlick flow control taps
Check craigslist...I've seen them for dirt cheap
+1 on the prelick taps..... Lots of them come with cheap chrome taps - get good ones as an upgrade or just buy them and swap them out.
when I see a foamy keg thread or line balancing thread I always mention flow control because they work. I Can't tell ya how many times I've heard "why do you keep pushing them" or "Whatta ya have stock in them"Of course I took note of their equipment including taps and tap systems. By far, the overwhelming majority are using Perlick taps. Many of those (probably most) using Perlick had the flow control model.
when I see a foamy keg thread or line balancing thread I always mention flow control because they work. I Can't tell ya how many times I've heard "why do you keep pushing them" or "Whatta ya have stock in them"
No..its because they work and solve all those issues....Good to hear the pros are using them....The sweet smell of validation
Bottling is a pain in the ass, ant recommendations as to where to buy a kegerator
Wanting at least a 2 tap and able to hold minimum of 3 kegs.
thanks
Not true at all. I have an under counter fridge..tiny. It holds three kegsCraigslist
2 taps and 2 kegs is doable, 3 kegs and a limit on space, you're dreaming
Not true at all. I have an under counter fridge..tiny. It holds three kegs
How loud is that model. I want to put it in the same room as my TV.Totally agree! I've been completely pleased with my kegerator! [emoji106]🏻[emoji481]View attachment 409538
How loud is that model. I want to put it in the same room as my TV.
Enter your email address to join: