General_Jah
Well-Known Member
- Joined
- Aug 29, 2015
- Messages
- 54
- Reaction score
- 3
Hey guys,
I'm planning on converting this new fridigaire freezer I bought for a kegerator and am having trouble deciding where to drill the holes in for the lines and temp control probe. This will be my first one.
You can view the parts specs here
The issue I'm having is the parts seem to indicate that the back has the condensor coils but it doesn't show how far up the unit they go, just that they start on the bottom.
I was considering drilling in through the side to run the lines as the parts list doesn't seem to show anything at all in the sides of it but read in another post there are typically important component there.
Any vets out there care to offer some advice?
Thanks
I'm planning on converting this new fridigaire freezer I bought for a kegerator and am having trouble deciding where to drill the holes in for the lines and temp control probe. This will be my first one.
You can view the parts specs here
The issue I'm having is the parts seem to indicate that the back has the condensor coils but it doesn't show how far up the unit they go, just that they start on the bottom.
I was considering drilling in through the side to run the lines as the parts list doesn't seem to show anything at all in the sides of it but read in another post there are typically important component there.
Any vets out there care to offer some advice?
Thanks
Last edited: