sam
Well-Known Member
Thought I'd share...
The stand was built with perforated angle iron (McMaster calls them "steel slotted angles"). I've got a McMaster warehouse less than 5 miles from the house so I picked everything up at Will Call. Here are the McMaster part numbers...
Took it for a test spin yesterday. I'm not finished building my mash tun so I used my Igloo with a piece of cement board underneath to protect it from the heat. Worked well... I can't wait until I have all the burners plumbed!
Some more pics from my brew day are posted here:
Samuel W. Scott's Photos - Brewing Stuff | Facebook
The stand was built with perforated angle iron (McMaster calls them "steel slotted angles"). I've got a McMaster warehouse less than 5 miles from the house so I picked everything up at Will Call. Here are the McMaster part numbers...
- 8968K26 2 Each 1-1/2" X 1-1/2", 6’ length | $17.32
- 4664T65 6 Each 2-1/4" X 1-1/2", 6’ length | $66.54
- 4664T22 16 Each Steel Corner Plate, 6"x 6" | $35.52
- 4664T61 1 Pack Bolts W/nuts & Washers | $12.89
- 8789T42 4 Each 400 lb. capacity caster | $91.84
Took it for a test spin yesterday. I'm not finished building my mash tun so I used my Igloo with a piece of cement board underneath to protect it from the heat. Worked well... I can't wait until I have all the burners plumbed!
Some more pics from my brew day are posted here:
Samuel W. Scott's Photos - Brewing Stuff | Facebook