benbradford
Well-Known Member
stuck faucets do break... a warm rag does the trick usually
emyers said:Yea im considering getting some hard drive rare earth magnets already, I have a feeling the Velcro is going to loose its strength.
Pre-made? Craigslist.
I picked up mine for $150. Swapped the single tower for a three tap.
I probably have about $250 in mine, total.
Corbono said:Check out my new little beauty. Perlick facets, stainless collar and 4 pressure tap rite.
BadgerBrigade said:Hi! Nice job! Can you tell me what "pressure tap rite" is?
LuiInIdaho said:It is a Tap Rite secondary regulator with four regulator controls. It can be used to dispense beer at four different pressures.
Mark.
BadgerBrigade said:Sounds like a really nice regulator, can you send me a link to where I can check one out... I bought a regular inexpensive regulator at my local homebrew shop but I have not yet completed my kegerator and I may be willing to change my current reg
Ya, 12" drip tray = $70
Stainless 12" drywall pan = $12
I'm with you!
Go to Barproducts.com, search for DTS-419. 19" SS drip tray for $18.
LuiInIdaho said:I just bought a four regulator TapRite from Keg works. I bought from here because the regulators are supposed to have check valves. Keg Works also sells primary regulators.
Mark
ajwillys said:Go to Barproducts.com, search for DTS-419. 19" SS drip tray for $18.
Corbono said:Check out my new little beauty. Perlick facets, stainless collar and 4 pressure tap rite.
I picked mine up for $300 with a dual tower, 10lb co2 tank and 1 keg. Sold that for $180 and funded the collar with 4 taps. I spend $50 upgrading to a 20lb tank for easier refill swaps and spend $50 on a 4 way gas spliter. So total investment $400+kegs. I got over $800 worth of gear in that initial deal. So yea CL can be better than making it your self.
Darkness said:We are getting started
Exactly! Me too. I did 2 chrome faucets and they are a pain in the ass if you dont use them daily. Looking to upgrade to Perlicks soon. Do Perlicks fit the shanks that come with the chrome faucets?
some helpful hints and ideas for me in here. I'm glad to find out that there is black paint that will do the job instead of trying to find a black freezer.
Is that a copper T? And if so how big is that mofo?
If you are referring to mine above it is textured spray paint from home depot.
I have a 420-Liter chiller plate fridge. Had a custom-made shelf fabricated to support the weight of the kegs. A few iterations later, I've added CO2 and Nitro lines to make them as interchangeable as I feel this week.
Here is my newly finished wall tap.
[/IMG]
Here is my newly finished wall tap.
Smcvail said:Here is my newly finished wall tap.
[/IMG]
I am not a home brewer
Not yet anyways!
Enter your email address to join: