Plasma Cutter in Calgary?

[louis]

Is there any one in Calgary Alberta who owns a plasma cutter who wants to help cut the top out of some soon to be keggles?

 

[dmcman73]

Use an angle grinder with a cutoff wheel for stainless, it's not that hard and plenty of "How To's" on this forum. I've made 4 of them and worked perfectly every time.

http://www.harborfreight.com/4-12-i...zIjoiMTEuOTkiLCJwcm9kdWN0X2lk IjoiOTA0OCJ9



http://www.harborfreight.com/pack-of-5-4-1-2-half-inch-metal-cutting-discs-66394.html

 

[ThatITGuy]

I wonder if you could get away with using a decent Dremel and a number of cut-off discs..

 

[CaptMogul]

If you use plasma put a few gallons of water in bottom. Saves scraping the flash off bottom, tough

 

[aeviaanah]

If using cut off wheels I would wear the diameter down on scrap metal prior to cutting keg. Smaller diameter cut offs cut arcs much better then larger ones