JaimesBeam
Active Member
I have an Italian Floor Corker that I've had for ten years. Lately I've been having problems with it. It chews up the top of the cork or doesn't push the
Cork down all way into the bottle. I bought it and my corks from BSG; run of
The mill #9 corks for 750ml wine bottles. It helps a little if I put the corks in
wet with StarSan, but does solve the problem.
I've taken it apart a couple of times it clean it out. It's a little rusty from getting
Damp over the years. What can I repaint the inside with? Should I ream out
The orifice on the bottom just a little bit? Should I buy a new corker, or are the
The corks just getting crappier? I've bottled maybe 1000 gallons with it.
Thanks, Jim
Cork down all way into the bottle. I bought it and my corks from BSG; run of
The mill #9 corks for 750ml wine bottles. It helps a little if I put the corks in
wet with StarSan, but does solve the problem.
I've taken it apart a couple of times it clean it out. It's a little rusty from getting
Damp over the years. What can I repaint the inside with? Should I ream out
The orifice on the bottom just a little bit? Should I buy a new corker, or are the
The corks just getting crappier? I've bottled maybe 1000 gallons with it.
Thanks, Jim