DCPiet
Active Member
Hi all,
So my kegging kit from kegconnection.com arrived today ban, and after looking over all the components I'm a little worried that they forgot something in assembly.
Specifically, the gas lines coming off the air manifold don't have hose clamps, and can be pulled off with very little effort. I've attached a photo to the bottom of this post, and it's also up here if it doesn't show up below: http://twitpic.com/4dcywe
So my question is, shouldn't there be hose clamps on here? Admittedly I'm a complete and total newb when it comes to kegging, but I can't see how this setup wouldn't cause some massive CO2 leaks.
For comparison, here's a photo from the kegconnection.com website showing the kit. It's very low resolution, but I'm pretty sure I can see hose clamps where mine has none.
Any advice is appreciated.
-piet
So my kegging kit from kegconnection.com arrived today ban, and after looking over all the components I'm a little worried that they forgot something in assembly.
Specifically, the gas lines coming off the air manifold don't have hose clamps, and can be pulled off with very little effort. I've attached a photo to the bottom of this post, and it's also up here if it doesn't show up below: http://twitpic.com/4dcywe
So my question is, shouldn't there be hose clamps on here? Admittedly I'm a complete and total newb when it comes to kegging, but I can't see how this setup wouldn't cause some massive CO2 leaks.
For comparison, here's a photo from the kegconnection.com website showing the kit. It's very low resolution, but I'm pretty sure I can see hose clamps where mine has none.
Any advice is appreciated.
-piet