Apollo
Well-Known Member
Ok HBT. I've googled the snot out of this with no luck. I've also been to ACE Hardware and they don't have anything to help.
The situation: I've inherited an old Hoff Stevens Hand pump/tap tower. I'm looking to secure it to the top of my Keezer for a single tap tower. The size of the coupler is not standard. It's somewhere between 1-1/4" and 1-1/2" diameter and the standard plumbing fittings don't match. I have ball lock kegs so I'd run a beer line from the beer barb on the bottom wide of the tap to the ball lock keg output.
Anyone out there have any ides on how to secure this to the lid of my Keezer? I've thought about scrapping the idea but due to who gave it to me, the uniqueness of the concept, and the potential low cost I'm reluctant to give it up.
Thanks HBT!!
The situation: I've inherited an old Hoff Stevens Hand pump/tap tower. I'm looking to secure it to the top of my Keezer for a single tap tower. The size of the coupler is not standard. It's somewhere between 1-1/4" and 1-1/2" diameter and the standard plumbing fittings don't match. I have ball lock kegs so I'd run a beer line from the beer barb on the bottom wide of the tap to the ball lock keg output.
Anyone out there have any ides on how to secure this to the lid of my Keezer? I've thought about scrapping the idea but due to who gave it to me, the uniqueness of the concept, and the potential low cost I'm reluctant to give it up.
Thanks HBT!!
