born2dive9702
Active Member
- Joined
- Nov 19, 2016
- Messages
- 35
- Reaction score
- 0
Hello everyone, I would like to thank you for your help in advance.
I recently purchased a maxi panther beer tower
http://www.micromatic.com/sites/5/downloads/865_6404-C.pdf
with 4 euro faucets like these http://www.chicompany.net/index.php...d=2064&zenid=f0dad63c60eac7677e92e836fced1b8e
I think I prefer my perlick 650ss https://www.kegworks.com/perlick-flow-control-faucet-stainless-steel but that is another story.
I have modified a chest freezer to use as a refridege with a Stc1000 which can control the temp by .1 degrees F
The tower is bolted to the top of the lid. I am using a Taprite regulators running stainless steel braided hose from the regs to the kegs.
I am using acuflex bev seal 3/16" line for the soda line.
My reguators are set to 22psi @36'f and which is carbing the diet soda 3.6GV. The line is 3/16" diameter connected and is 10ft long. it is connected to a 19" long 1/4" stainless tube that runs up to the head. the faucets have a 3" shank. From center of the keg to the top of the head is 29" and 12" on the horizontal.
I have cleaned the entire system with starsanz sanitizer and distilled water. I am rather sure that I have everything set up and balanced correctly.
I did a flow rate test with water and have 1.3oz/sec which is good for me I prefer a slower pour.
The soda in the tanks is at 35.9'f I can not get a accurate temp on the soda coming out of the faucet because it is all foam.
What is going on what is causing the foam? have I missed something obvious.
Please let me know I am having a nightmare with this.
I recently purchased a maxi panther beer tower
http://www.micromatic.com/sites/5/downloads/865_6404-C.pdf
with 4 euro faucets like these http://www.chicompany.net/index.php...d=2064&zenid=f0dad63c60eac7677e92e836fced1b8e
I think I prefer my perlick 650ss https://www.kegworks.com/perlick-flow-control-faucet-stainless-steel but that is another story.
I have modified a chest freezer to use as a refridege with a Stc1000 which can control the temp by .1 degrees F
The tower is bolted to the top of the lid. I am using a Taprite regulators running stainless steel braided hose from the regs to the kegs.
I am using acuflex bev seal 3/16" line for the soda line.
My reguators are set to 22psi @36'f and which is carbing the diet soda 3.6GV. The line is 3/16" diameter connected and is 10ft long. it is connected to a 19" long 1/4" stainless tube that runs up to the head. the faucets have a 3" shank. From center of the keg to the top of the head is 29" and 12" on the horizontal.
I have cleaned the entire system with starsanz sanitizer and distilled water. I am rather sure that I have everything set up and balanced correctly.
I did a flow rate test with water and have 1.3oz/sec which is good for me I prefer a slower pour.
The soda in the tanks is at 35.9'f I can not get a accurate temp on the soda coming out of the faucet because it is all foam.
What is going on what is causing the foam? have I missed something obvious.
Please let me know I am having a nightmare with this.