Which part on the step bits...good or crap?I always look for good tool deals at garage sales. If I see a 70s/80s vintage Craftsman hand tool or power tool. I'll snap it up. I use an old corded Craftsman drill to run my grain mill. It weighs about 10 lbs, but it's a beast.
+1 for HF step bits.
Off topic but I had the most impressive set of totally mismatched tools. I cruised Tulsa, OK garage sales from 1991-1998 as a lot of of the old field engineers and 1950's roughnecks where passing away. I picked up (replacement value) about $10k in vintage Craftsman, Lisle, Snap-on and Mac tools. I spent about $300. My biggest "score" was 50-300# micrometer 1/2" torque wrench in box with calibration label...$10.
Ebay has ruined this and the toolbox was stolen from my garage while I was in Iraq...along with 22 $15 ball lock kegs. Granted it was 9 years ago now and I have moved on.
I am going to go in the corner and cry now.