I have been following this thread for a while and pulled the trigger tonight...
the kitchen sink decided to leak last night while brewing some beer. I had plans to go fishing with some friends the following day but figured I would stop by the local hardware joint after that. Fishing was worth it...
on the way home i ran into a floor model for cheap... $129!
I got home and started fiddling... I have pretty much read this thread but if i missed something that has already been covered. smack me.
This is what I am getting rid of...
I was wondering if i could leave the actual light where it sat and still fit in two kegs... I think i did. I cut the light thermo housing in half and re mounted the light where it was supposed to be...
Then extended the wires to the "back shelf"
The metal line that is the temp sensor easily pulled out for me.. I attached it with the wires an will see how that works.
Here is it with 2 kegs...
any reason pulling out the sensor line is bad?
with the light cut in half and the door shut.
I am waiting on the tower to show up...
not sure if this was worth the time.. I know most of the important bits have already been covered in this thread.