GreatBeerTour
Well-Known Member
I am creating a single vessel ebiab and have a question- please forgive my stumbling description- thanks in advance
Picture the kettle- specifically the lid- hot liquid flowing through a hose into/through the top of the lid- so far so good?
now under the lid i want/need two places for the liquid go-
First drip/spray over the grain during the mash-
Secondly, at the end of the boil I want a tube to extend below the surface with a bend to swirl the wort.
I'm thinking about a fitting that will accept 1/2 copper and hold firmly- no need for holding pressure but firm enough to keep the pipe from falling out.
maybe a compression fitting with the ferrule replaced by an o-ring? is a 'quick connect' fitting what i'm looking for? something fairly simple- no tools- I know it will be hot-
Ideas?
Picture the kettle- specifically the lid- hot liquid flowing through a hose into/through the top of the lid- so far so good?
now under the lid i want/need two places for the liquid go-
First drip/spray over the grain during the mash-
Secondly, at the end of the boil I want a tube to extend below the surface with a bend to swirl the wort.
I'm thinking about a fitting that will accept 1/2 copper and hold firmly- no need for holding pressure but firm enough to keep the pipe from falling out.
maybe a compression fitting with the ferrule replaced by an o-ring? is a 'quick connect' fitting what i'm looking for? something fairly simple- no tools- I know it will be hot-
Ideas?