Feed line

[radio2]

So I bought this Kegerator set up used minus the kegerator, (tank,regulator, lines,tap and sipgot) My question is the feed line is 1/4" X 20' and is not that clean as I can see some spots of dried beer in there so should I just replace the line or is there a way to clean it?

 

[nettekdl]

You could hit it with beer line cleaner, though I would suggest just replacing it, it's cheap. From personal experience I would also suggest using 3/16 not 1/4.

 

[marckw]

Replace it. You'll never know what's been through it previously.

 

[radio2]

Thank's that what I thought

 

[outside92129]

Definitely replace with barrier line, 3/16". It last longer, doesn't absorb flavors to transfer to other beers, and has greater resistance to flow (which is needed for higher CO2 pressures).

 

[day_trippr]

If the experiences offered by Bev Seal Ultra 235 users are indicative, barrier lines have lower resistance than non-barrier lines...

Cheers!

 

[outside92129]

If the experiences offered by Bev Seal Ultra 235 users are indicative, barrier lines have lower resistance than non-barrier lines...

Cheers!

True, i typed too fast. My bit about greater resistance stems from 3/16 over 1/4, not from the barrier line.