EuBrew
Well-Known Member
I'm getting ready to wire my stand, control panel is done but I'm not sure I understand how to wire the temp sensors using the Dallas one wire daisy chain topography. I have 2 XLR connectors that will each lead to 3 sensors for a total of 6. Is it as easy as running the wire from the XLR connector at the panel and splicing in temp sensor 1, run a bit more wire and splice in sensor 2, then terminate the run at sensor 3 for each run??
Second, anyone know what kind of connector this is and where I can find the female side to make wiring my valves much easier??
Second, anyone know what kind of connector this is and where I can find the female side to make wiring my valves much easier??