BansheeRider
Well-Known Member
- Joined
- Dec 11, 2012
- Messages
- 1,505
- Reaction score
- 101
Ok this is my first keg and I have some questions. I racked from primary into my keg with no issues. Put the keg into the kegerator and set Co2 to 30psi for 24 hours. I then reduced psi to 10, tried a pint and it was flat and cloudy. The temps were between 36-38 for the first 24 hours then I turned the temp up to about 44 degrees. I have left the psi now at 10-12 psi.
It has now been 36 hours and the beer is flat and cloudy, super cloudy. I have poured out about 4 pints to see if it clears up but no luck. How long will it take for my beer to clear and these cold temps? Also how long will it take for my beer to carb? I forced carbed at 30psi for 24 hours and then I turned it down to 10psi. I did not have the cloudiness problem when I bottled at room temp. Temp in the kegerator now is 44 degrees.
It has now been 36 hours and the beer is flat and cloudy, super cloudy. I have poured out about 4 pints to see if it clears up but no luck. How long will it take for my beer to clear and these cold temps? Also how long will it take for my beer to carb? I forced carbed at 30psi for 24 hours and then I turned it down to 10psi. I did not have the cloudiness problem when I bottled at room temp. Temp in the kegerator now is 44 degrees.