Alright guys, I'm getting going on my second keezer (RIP first keezer). My first had a tower but this one will have a collar. I built a top and platform for the first one and had a pretty hard time with the mitres. There were a bunch of spots I was way off and needed filler pieces and putty to make right. I'd like to not do that with my collar. I picked up a piece of Red Oak that cost 40 bucks so I would really like to not screw up this piece of wood. Any tips on cutting my mitres? I have a Mitre saw and a circular saw with an angling fence. I also have a table saw but I don't think it's big enough for my boards.