tcarcieri
Member
- Joined
- Mar 31, 2020
- Messages
- 7
- Reaction score
- 2
Good morning,
First and foremost, hope everyone and their family/friends are doing well.
My kegerator issues this very annoying and unstoppable tone once it hits about 45-50 degrees. I bought an Inkbird controller thinking I could bypass the digital thermostat but that didn't work.
What I would like to do is bypass/cut the correct wire going to the top display panel of the board. There are 4 wires: brown, red, yellow and green.
If I don't plus that wire in to the display board, it doesn't power on. The other end of the that wire harness is on the bottom of the kegerator into another control board. The unit works when I plug it in, I just need to bypass that particular wire powering the thermostat/display/tone functionality.
Forget the whole warranty thing.
Any suggestions?
Much appreciated,
T
First and foremost, hope everyone and their family/friends are doing well.
My kegerator issues this very annoying and unstoppable tone once it hits about 45-50 degrees. I bought an Inkbird controller thinking I could bypass the digital thermostat but that didn't work.
What I would like to do is bypass/cut the correct wire going to the top display panel of the board. There are 4 wires: brown, red, yellow and green.
If I don't plus that wire in to the display board, it doesn't power on. The other end of the that wire harness is on the bottom of the kegerator into another control board. The unit works when I plug it in, I just need to bypass that particular wire powering the thermostat/display/tone functionality.
Forget the whole warranty thing.
Any suggestions?
Much appreciated,
T
Last edited:
