OP
OP
HarpuaScorpio
Well-Known Member
It wouldn't hurt to fuse the voltage wires to the DVA, but I don't think it's necessary. Personally, I would use 20-22AWG wire for that as the DVA will draw almost 0 current. And in the case of fine wire, the wire itself will fuse in the event of a dead short. If your enclosure is a metal box, then there is little risk involved (as long as you follow all the other safety rules.)
Brew on
Awesome! Thank you. The box is metal so I should be all good to go. The box is fully grounded and everything else is wired as you see it above.
This is the last bit of wiring I needed to figure out, so my full controller build thread will be coming soon.
