Wiring an xlr pt100 to Inkbird ipb-16s

[mr_rogers]

It's been a while since I last posted but I've got a question I can't seem to find an answer to!

I just bought an Inkbird IPB-16S but I'm wanting to upgrade the temperature probe with a PT100 using XLR connections out of the project box.

the Inkbird currently has an 1/8th inch jack temp probe that is wired with only two wired described as NTC and Ground. Do I wire it so that both of the red wires contact the NTC side of the Board and the single Blue wire contacts the Ground?

I'll add some photos shortly.

Thanks!

 

[mr_rogers]

 

[doug293cz]

You can't swap an NTC thermistor probe out and replace it with a PT100 unless the PID has multi probe capability. Doesn't look like the IPB-16S has the required capability.

Brew on