So I thought I would stop commenting and start contributing for once. I will start by saying I absolutely could have done this differently but I worked with parts I already had but oh well.
I bought a water filter for my brew water because I'm still not sure what the make up of it is. Its well water so I grabbed a filter and set it up. After words I realized that I couldn't run hot water through it; only rated for 100f and mine comes out at 160+f.
My Solution was to build a bypass around it. I went with PVC for cost reasons.
Here it is cut up and laid out before fully assembling it.
Right side/Input:
Left side/Output:
The Whole Thing:
Here is the filter in a little table i built (not my best work)
Input assembled:
Output assembled:
Finished assembly:
Could I have done this differently? Yes. Could I just have bought a second hose to use? Yes. But thats not how i wanted it. Overall it only cost $30.
Cheers everybody
I bought a water filter for my brew water because I'm still not sure what the make up of it is. Its well water so I grabbed a filter and set it up. After words I realized that I couldn't run hot water through it; only rated for 100f and mine comes out at 160+f.
My Solution was to build a bypass around it. I went with PVC for cost reasons.
Here it is cut up and laid out before fully assembling it.
Right side/Input:
Left side/Output:
The Whole Thing:
Here is the filter in a little table i built (not my best work)
Input assembled:
Output assembled:
Finished assembly:
Could I have done this differently? Yes. Could I just have bought a second hose to use? Yes. But thats not how i wanted it. Overall it only cost $30.
Cheers everybody