I posted what I supposed were the pins here (previous page). I'll probably give it a try tonight.I don't think it should be a problem to use the nano for the upload. The only thing that *may* be a problem is if the voltage regulator doesn't have the oomph, but I don't think that will be a problem. A bit of googling should give you the correct pins to use.
Please post back how things turn out.
Good luck!
So what is everyone's setup for data logging with BrewPi software? Details please!
EDIT: I'm now at the point that in serial monitor, I see the correct prompt:Please post back how things turn out. Good luck!
With my first one I had to have the stc plugged in to 120v to be able to flash it, which I think was said to be a no no, but alas I am here to tell the tale.
1. Change SP9 to nxt (Next) It could then specify another profile to link to (range 0..5) or 9 (revert to th mode with last setpoint (SP8)
That way profiles could be linked if needed.
However is this really need? Its just a sugestion!
2. Does pressing up & down together read out the version number only when in run mode.
3. How many steps to a ramp are there in V 1.03
Now I also want to use my Arduino to log temperatures.
No problem with the sensors and code its just a question of how to upload to my computer. I don't want to use anything more than the serial interface.
So basically set the Arduino to record mode and store the data in Ram.
Then later upload the data via the serial port and cut and paste from the serial monitor window.
However due to lack of eeprom I will have to keep the Arduino powered and connected to a laptop. Dig out spare laptop!
Any othre thoughts?
Also when I dowloaded the IDE 1.0.5 it comes up with an error in application startup (on Windows 7 Pro 32 bit) so had to use 1.0.1 but it worked!
Enter your email address to join: